PRODUCTS

INSULATION PRODUCTS

Among our insulating products, the polystyrene microbead insulation is injected with a water-based acrylic binder into a specially created space.

The agglomerate dries and sets in a few days.

Surpassing the requirements of quality standard CAN/ULC S701.01.2017 (including modifications), our insulation products are made from rigid polystyrene, factory-fabricated in board form.

Ecobill Graphite polystyrene

Ecobill MD/®

100% RECYCLED PRODUCT

An effective product

Ecobill MD/® is a trademark registered in Canada and owned by Inject-Styrene Technology on injection-agglomerated polystyrene bead insulation products, expanded or extruded.

Graphite polystyrene

  • High-performance insulation (R-4.3/in.)
  • Hydrophobic
  • No settling or swelling
  • 25% to 50% recycled content

Economical

  • Low installation costs
  • Quick installation
  • Lower energy costs
  • Enhancing the value of existing buildings

Environmental product

  • Protecting built heritage
  • No construction waste
  • Significant reduction in GHGs
  • Circular economy

Insulation technology

  • Without demolition
  • Work on inhabited dwellings
  • Energy efficiency (thermal value + air convection reduction + existing value)
  • Eco-materials

Product features

  • High thermal value
  • High water vapour permeance
  • Superior injection efficiency
  • Made up of 98% air and only 2% matter
  • Stable, without swelling or shrinkage
  • Dust- and vapour-free
  • Non-contaminating for materials in place
  • Recycled and recyclable
  • Does not encourage vermin
  • Does not promote mould
Isobill Injected insulation

Isobill MD/®

An effective product

Isobill MD/® is a trademark registered in Canada and owned by Inject-Styrene Technology on injection-agglomerated polystyrene bead insulation products, expanded or extruded.

Blown-in insulation

  • High-performance insulation (R-3.86/in.)
  • Hydrophobic
  • No settling or swelling

Financial benefits

ISOBILL MD/® provides high-level insulation at a cost up to 10 TIMES lower than the investment required to demolish interior or exterior walls.

Allow one to two days for a house or 2-family dwelling, which saves time and has little or no impact on occupants or tenants.

Product features

  • Water-washable product
  • Efficient void filling
  • Obstacle avoidance
  • No undue pressure during installation
  • Stable over time
  • Water and air permeable
  • Allow walls to breathe
  • Non-capillary, does not retain water

Technical advantages

  • Using the process
  • Quick and easy to install
  • Little impact on occupants
  • Cleanliness of execution
  • Installations remain in place
  • Countertop cabinets or equipment
  • Etc

Environmental product

  • Recyclable product
  • Reuse in the same process after simple grinding
  • Use of recycled polystyrene
  • Condensation and surplus recovery